8-Channel Broadcast Monitor

The COMM-connect 3024 Broadcast Power Monitor can control up to 8 external RF Measuring heads. The high dynamic range with external couplers and RF measuring heads cover from 1W to 1MW. The Power conversion algorithms handles multi carrier, multi mode, peak, average and RMS signals. The power readout is auto scaled and VSWR can be calculated between any probes. Also the measured and calculated results along with alarms can be shown in the local LCD. The instrument has SNMP support to allow network management. The instrument can be configured for VSWR and Power limits to give alarms. The alarms can be configured to operate relay drivers or isolated Optcouplers. The alarms can also be configured as SNMP traps sending relevant information to the network control center or sending an e-mail. All values are logged and time stamped to a USB stick every minute. The COMM-connect 3024 WEB enabled Power Monitor gives an unlimited number of application to monitor and control the last part of your RF network installation from transmitters to the antenna.

Type 3024:


· Forward Power
· Reflected Power
· True RMS (3015 & 3016 probes)
· True Power Level (3026 probe)
· Configurable alarms
· Relay output
· Local display
· Web server
· SNMP Enabled with traps
· High accuracy
· 19" Panel



· Frequency range:
   · 3015 Probe: 470 - 860MHz
   · 3016 Probe: 50 - 250MHz
   · 3026 Probe: 10 - 2500MHz
   · 3020 DDC: depends on variant
· Temperature range: 0C to +50C
· Power Supply: 85-264VAC, 50/60Hz



· Cost effective

· Site monitoring

· Remote site surveillance

· Rack mount

· Web administration

· Wide selection of probes

Web Tool: